Trim, offset and round sketches
Clean profiles before extrusion and shape corners deliberately.
Updated:
Trim and extend
Trimming removes a selected segment up to suitable boundaries. Extend carries a segment to a matching limit. Check that the intended profile remains closed. Removing one short segment accidentally can open the whole face.
Edit corners
Sketch fillet replaces the meeting of two straight legs with an arc; sketch chamfer uses a straight connection. Select both intended legs near their corner and enter the radius or chamfer amount. The value must fit both legs. A sketch fillet changes the outline before extrusion. A body fillet changes an existing spatial edge. Both can produce rounded plan corners, but the saved construction differs.
Offset
Profile offset creates a parallel outline. Check direction and tight corners: a large inward offset can erase small regions or create intersections. Offsetting a profile is not automatically equivalent to hollowing a three-dimensional body. Example: draw a 40 by 25 mm rectangle, fillet one corner R2, clean the closed profile and extrude it 5 mm.