Skip to content
ShapeAnywhere Wiki
Solid modeling

Create and print threads

Consider cylindrical support, pitch, length and export geometry together.

Updated:

Select suitable support

Threads need a suitable cylindrical surface. A circular edge alone is not sufficient. External and internal threads differ by material side; an internal thread also needs enough material behind the bore.

Define dimensions

Pitch is axial advance per revolution. Thread length and start offset limit the treated region; new threads leave a small end margin. The assistant shows the matching outer stock diameter or pilot bore. If the selected cylinder does not match, adjust the hole or cylinder in regular CAD first; the assistant does not drill automatically. Fit presets provide 0 / 0.10 / 0.20 / 0.30 mm radial clearance as printing guides, not standardized tolerance classes. An optional entry chamfer is modeled at the selected start only; its size must fit the wall thickness. Check nominal diameter, clearance and handedness together. A bounded section can be easier to compute than a thread ending exactly on a complex cap. Printing requires actual thread geometry in the export. Cosmetic display alone is not a printed thread. Applying verifies the same native geometry as STL/3MF export and blocks invalid edits. This is still a simplified 60° profile, not certified ISO fit geometry. Inspect the exported file in the slicer.

Test fit

Before a long screw, make a short male/female pair with documented clearance. Print, clean and test by hand. Correct geometry can still fit too tightly because of material, layer direction and printer accuracy.